![]() The scanner came up with P0128, which has to do with the thermostat, the coolant, or the coolant temperature sensor thing. After leaving from work a bit later, I headed over to Autozone, to get it scanned and see what the problem was. ThanksĮdit: Oh, and its probably worth mentioning that the temperature gauge hasn’t gone past the middle mark at all. This morning when I was on my way to work, the check engine light came on. What could the problem be? Why is the low coolant light only coming on for short periods of time? (usually only once each time I drive it recently, sometimes not at all). The display will then reveal why the check engine light is illuminated. Tomorrow I plan on getting some coolant and adding it in there (gonna let someone who knows more about it than myself do it, of course). Press the lower left button on the left side. When an engine misfires, one or more of the cylinders doesn’t produce the power it should. BIG RED AT42002R Torin Steel Car Jack Stands: 2 Ton (4000 lb) Capacity, Red, 1 Pair. Keep in mind the car did sit for about a year before I bought it… SCHRADER TPMS Sensor - (Clamp-in, 315MHz) Toyota OE 42607-33011 & 42607-06011. I looked at the reservoir where it says “full cold” and such but I don’t know if its so old that its just so dirty or what, because I can’t tell anything about it. Disconnect the radiator hose from the water pump (if present). Remove the cooling fan shroud using a Phillips head screwdriver. Follow these steps to change the engine coolant: Remove the front passenger side wheel cover. Is removal of t-stat really necessary, wont the engine warmup and t-stay open as your flushing, and yes Im draining the block. To fix this problem, youll need to change the engine coolant. Reinstall t- stat and fill with new antifreeze. (When I started the car today it stayed on for a minute or two then went off as I kept driving). On 2.7L, Haynes manual says to remove thermostat after coolant is drained and reinstall housing without t-stat, run with distilled water for flush, drain again. This will ensure maximum protection for your car’s cooling system. Followed the directions and the check engine light went off, it uses less coolant. Drain the system again, flush once more with water, before filling the system with Prestone Coolant/Antifreeze. my engine coolant gone out after 100kms, after. Service engine light is on for evap small leak (think that’s unrelated to the coolant light?) anyways, recently the coolant light has come on for less than 60 seconds and then went off. Pour Prestone Cooling System Flush into expansion tank and top up with water to the fill line. ![]() Some can be minor problems such as tightening the gas cap, and others can be serious problems like engine issues. Bought a used 2000 Pontiac Grand Am GT1 from someone a month or two ago. Check engine lights can turn on for a number of reasons. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |